Test AutoCAD with each change. For more information about troubleshooting Windows user profiles, refer to Microsoft support and documentation. To determine the specific customization that is causing the problem, start by testing a new local or domain user without any policies or restrictions applied. Then begin adding customizations one at a time or in small groups. Testing strategy for failures when running AutoCAD as a restricted user Always refer to specific product documentation for details and requirements. Many Autodesk products do not support restricted or roaming users even in the default, out-of-box configuration. Other Autodesk products, including verticals built on AutoCAD technology, may have different requirements and recommendations.Always back up essential data files, export a copy of the current registry settings and set a system restore point before making changes to the Windows Registry or user profile folders. Advanced troubleshooting knowledge and access rights will be required for both testing and resolving these issues. The information below is for system and network administrators only. Just save the Setup.ini file and run Notes, read this information carefully before proceeding:ĪutoCAD and AutoCAD LT are only tested against out-of-box Microsoft restricted users and roaming users. Any customization or restriction placed on users could have unexpected results in AutoCAD and are considered unsupported operating environments. If you change the value to the right of the equals sign to x86, you’ll be able to install. When the installer recognizes your 64bit OS it uses the 圆4 path and says you can’t install. Near the top of the file you’ll notice two paths, X86_IMAGE_PATH and X64_IMAGE_PATH. Then open the Setup.ini file, located in the recently copied installation folder, using notepad. What you need to do is copy the content of your installation disc to your hard drive. The solution in this case is fairly well known, but I wanted to share it with our readers because it’s so simple and helpful. For instance, I’ve gotten quite a few calls about installing Land Desktop on a 64bit machine. The problem is that not everyone who’s ready for a new machine is ready to upgrade their Autodesk products. At the same time, there’s a big push to upgrade to 64bit machines. I made the move a couple of months ago and I’ve actually enjoyed the new OS– though somehow I still can’t use a ribbon created by anyone other than Autodesk. A lot of people are upgrading to Windows 7 these days.
0 kommentar(er)
